Induction heater 1.5kW

Applicable in automotive, railway and shipbuilding industry, metalworking and maintenance

It finds application in operations that require speed and flexibility and pose a risk of damage around heated parts with naked flame (upholstery, pain, rubber sleeves, electrical installation, etc.).

Facilitates removal of rusty bolts and old parts, heating of exhaust pipelines, bolts, nuts, bearings, tools before hardening, gluing, soldering, and ideal for defrosting

It replaces heating by oxyacetylene and butane-propane flame

Voltage 220V, 50Hz

Power supply cable 1.5 m

Coil gun holder 0.8 m

Power 1.5 kW / 3.2 kVA

Consumption 8 A

Do not exceed the operating cycle DIH-1.5kW – 2 minutes heating (on) a 2 minutes cooling (off)

Ingress Protection Code IP20

Operating frequency 25 - 65 kHz, automatic adjustment

Equipment of protection class I

Protection against overheating and overload of the source and short circuit of the coil

Flame- and spark-free heating

Fan cooling

Output short circuit protection

PF (power factor) 0.99 (PFC)

Continuous heater / loader 100 %

IGBT transistors

Coil circuit break protection

Dimensions 210 x 140 x 90 mm

Weight 4.6 kg

12 month warranty

Extension cords – if necessary, you may use only the following extension cords:

up to 5 m with 2.5 mm2 diameter

up to 15 m with 4 mm2 diameter

When using the device with an alternate source of power – e.g. with mobile electric generator, it is necessary to use a quality alternate source of sufficient power and AVR quality control

Use a generator with a power output of at least 3-4 kW, or DC / AC inverter with a power output of 2-3 kW and only with a sine wave – do not use the inverter with a square or quasi-sine wave

Failure to comply with the above requirements may result in damage to the device and void the warranty